The technical data contained herein is accurate to the best of our knowledge. Centri Coatings & Systems Corporation warrants that coatings represented herein meet their formulation standards. No other warranty is expressed or implied, including warranties of merchantability and fitness for a particular purpose. Published technical data and instructions are subject to change without notice. Contact your Centri Representative for current technical data and instructions.
De Greaser D-G is an industrial grade grease and oil remover. It is both an emulsifier and detergent. It is used to clean and degrease engines, chasis, gears and other equipment. Simply brush or spray De Greaser D-G on the item to be cleaned, then flush with solvent or water. Heavy concentrations of oil or grease may take more than one application. Also, it may be necessary to allow De Greaser D-G to penetrate for 5 minutes before rinsing off.
De Greaser D-G is effective in removing oil stains from concrete. Apply, wait 5 to 10 minutes, then thoroughly soak with solvent (mineral spirits, Naphtha, or Kerosene), agitate with a stiff brush and hose off with water.
Appearance.............................Liquid, amber color
Viscosity (#4 Ford cup)............Low: 10 - 12 sec
Combustible! Contains Petroleum Distillate! Keep away from heat and open flame and use only with adequate ventilation. Avoid any prolonged breathing of vapor of spray mist and prolonged or repeated contact with skin. IN CONFINED AREAS: Workers should wear fresh airline respirators to avoid breathing concentrated vapors. Adequate fresh air must be circulated during application. Hypersensitive persons should wear gloves or use protective cream. Workers should be required to use non-ferrous tools and wear conductive and non-sparking shoes in areas where explosion hazards exist. All lights and electrical equipment should be explosion-proof. Keep container upright to prevent leakage, and keep closed when not in use. In case of spillage, collect and dispose of in accordance with local applicable regulations. In the event welding or flame cutting is performed on empty containers of this product, do so in accordance with instructions in USA Standard Z49.1 "Safety in Welding & Cutting".
FIRST AID: In case of skin contact, flush with plenty of water. For eyes, flush with plenty of water for 15 minutes and get medical attention. If affected by inhalation of vapor, remove to fresh air. MSDS is available.
KEEP OUT OF REACH OF CHILDREN. FOR INDUSTRIAL USE ONLY.