SECTION I
Manufactured by:
CENTRI COATINGS & SYSTEMS CORPORATION
1010 Gentry
North Kansas City, MO 64116
(816) 221-1146
centri@centricoatings.com
Emergency Telephone Number:
(816) 221-1145
Chemical Name & Synonyms:n/a
Trade Name & Synonyms:White Shop Primer #101
Chemical Family:Paint
Formula:Proprietary
SECTION II--HAZARDOUS INGREDIENTS
Pigments X Catalyst - Vehicle - Solvents X Additives X Other -
Paint, Preservatives & Solvents (% and TLV (units)):
Hazardous Mixtures of Other Liquids, Solids, or Gases (% and TLV (units))
Cobalt Solution, 0.2%, 2 ppm
VM&P Naphtha, 26%, 300 ppm
Xylene, 16%, 100 ppm
SECTION III--PHYSICAL DATA
Boiling Point (deg. F):245 - 300 degrees F.
Vapor Pressure (mm Hg):unk
Vapor Density (Air = 1):Heavier than air
Solubility in Water:Negligible
Specific Gravity (Water = 1):1.22
Percent Volatile by Volume (%):n/a
Evaporation Rate (Ether = 1):Slower than ether
Appearance & Odor: White, typical naphtha odor
SECTION IV--FIRE & EXPLOSION HAZARDS
Flash Point and Method:50 degrees F (TCC)
Flammable Limits/% Volume in Air:Lower: unk
Extinguishing Media: Carbon dioxide, foam, dry chemical, water fog.
Special Fire Fighting Procedures & Precautions:Wear self-contained breathing apparatus and protective clothing to prevent contact with skin or eyes.
Unusual Fire & Explosion Hazards:Keep away from heat, open flame and sparks. Do not apply to hot surface.
SECTION V--OCCUPATIONAL EXPOSURE LIMITS
OSHA PEL/TWA:-
OSHA PEL/CEILING:-
ACGIH TLV/TWA:10 mg/m3 (as dust)
ACGIH TLV/STEL:-
OTHER:-
SECTION VI--EMERGENCY & FIRST AID PROCEDURES
Eye Contact:Short term liquid or vapor contact may result in slight eye irritation. Prolonged and repeated contact may be more irritating. Use safety glasses. Flush with water for 15 minutes while holding eyelids open. Call a physician
Skin Contact:Prolonged and repeated liquid contact can cause defatting and drying of the skin which may result in skin irritation and dermatitis. Wash with soap and water. Remove contaminated clothing and shoes; do not reuse until cleaned. If persistent irritation occurs, get medical attention.
Inhalation:High concentrations or prolonged exposure to lower concentrations may be slightly irritating to mucous membranes. Remove victim to fresh air and provide oxygen if breathing is difficult. Give artificial respiration if not breathing. Get medical attention.
Ingestion:Liquid ingestion may result in vomiting; aspiration (breathing) of vomitus into the lungs MUST BE AVOIDED, as even a small quantity in the lungs may result in chemical pneumonitis and pulonary edema/hemorrhage. DO NOT INDUCE VOMITING. If vomiting occurs spontaneously, keep head below hips to prevent aspiration of liquid into the lungs. Get medical attention.
Note to Physician:Overexposure can lead to central nervous system depression, producing such effects as headache, nausea and loss of consciousness. DO NOT INDUCE VOMITING.
SECTION VII--REACTIVITY
Stability:Stable
Hazardous Polymerization:Will not occur
Conditions & Materials to Avoid:Strong oxidizing agents.
Hazardous Decomposition Products:Thermal decomposition may yield carbon monoxide.
SECTION VIII--ENVIRONMENTAL PROTECTION
Spill or Leak Procedures:
Keep sources of ignition (flames, hot surfaces, and electrical static, or frictional sparks) isolated from the spill. Flush spilled material into suitable retaining areas or containers with large quantities of water. Small amounts of spilled material may be absorbed into an appropriate absorbent. DISPOSE OF IN ACCORDANCE WITH LOCAL, STATE AND FEDERAL REGULATIONS.
SECTION IX--SPECIAL PRECAUTIONS
Keep closures tight and upright to prevent leakage. Keep containers closed when not in use. Do not store above 120 Deg. F. Keep away from heat, sparks, and open flame. Use only with adequate ventilation. Use approved grounding procedures. Prevent prolonged breathing of vapor or spray mist. Prevent contact with skin and eyes. Do not take internally. For industrial use only. Keep out of the reach of children.
Disclaimer of Liability
The infomation in this MSDS was obtained from sources which we believe are reliable. However, the information is provided without any warranty, express or implied, regarding its correctness. The conditions or methods of handling, storage, use and disposal of the product are beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product. This MSDS was prepared and is to be used only for this product. If the product is a component in another product, this MSDS information may not be applicable.
