Wood Shield
Centri      
Product Data
WOOD SHIELD is a wood protector.  Since wood has an affinity to absorb oils, this coating was designed to give the maximum penetration, thus filling the voids with natural oils.  It contains components that do not support fungal organisms and repel moisture, thereby providing an excellent, durable coating.

WOOD SHIELD  protects wood for years.  It can be applied to weathered wood, or new wood as long as it is clean and dry. WOOD SHIELD is suitable for coating fences, decks, roofs and other wood structures.  The wood must be dry for maximum penetration.  CAUTION:  Wood surfaces that are to be used to walk on or sit on, such as deck areas, should be allowed to cure until no residual traces of WOOD SHIELD are present.  It may require several days.  Check surfaces by wiping with a clean rag to ensure no traces are present before activity.


Physical Characteristics

Appearance................................................... Clear (Special Colors)
Weight/Gallon................................................ 7.20 lbs./gallon
Viscosity....................................................... 10 - 11 seconds (#4 Ford Cup)
Coverage.......................................................  250 - 300 sq. ft./gallon
       *Dry Time...................................................... 1 - 2 hours

*Depends on temperature and porosity of wood.


Instructions

Clean surfaces free of dirt, loose paint and any rotted sections. WOOD SHIELD  may be applied to surfaces by brush, spray or dip.  A small, plastic Hudson sprayer works very well.  Apply a liberal coat.  Porosity of surfaces will vary, so more than one application may be necessary. WOOD SHIELD  is formulated to allow maximum penetration.  Use product "as is".  When spraying wood fences and shingles, saturate thoroughly, directing the spray nozzle on all exposed sides, particularly on the edges.


Cautions

Combustible!  Contains Petroleum Distillate!  Keep away from heat and open flame and use only with adequate ventilation.  Avoid any prolonged breathing of vapor of spray mist and prolonged or repeated contact with skin.  IN CONFINED AREAS:  Workmen should wear fresh airline respirators to avoid breathing concentrated vapors.  Adequate fresh air must be circulated during application.  Hypersensitive persons should wear gloves or use protective cream.  Workmen should be required to use non-ferrous tools and wear conductive and non-sparking shoes in areas where explosion hazards exist.  All lights and electrical equipment should be explosion-proof.  Keep container upright to prevent leakage, and keep closed when not in use.  In case of spillage, collect and dispose of in accordance with local applicable regulations.  In the event welding or flame cutting is performed on empty containers of this product, do so in accordance with instructions in USA Standard Z49.1 "Safety in Welding & Cutting".  

FIRST AID:  In case of skin contact, flush with plenty of water.  For eyes, flush with plenty of water for 15 minutes and get medical attention.  If affected by inhalation of vapor, remove to fresh air.

WARRANTY
The technical data contained herein is accurate  to the best of our knowledge.  Centri Coatings & Systems Corporation warrants that coatings represented herein meet their formulation standards.  No other warranty is expressed or implied, including warranties of merchantability and fitness for a particular purpose.  Published technical data and instructions are subject to change without notice.  Contact your Centri Representative for current technical data and instructions.